Canadian Electrical Industry News Week

December 5, 2021

EIN Building Sept 400Investment in building construction declined 0.7% to $17.5 billion in September, continuing a downward trend that started in May. A decrease in the residential sector was partially offset by a small increase in the non-residential sector.

On a constant dollar basis (2012=100), investment in building construction decreased 1.5% to $12.0 billion.

Residential construction investment continues to decrease

Residential construction investment decreased 1.6% in September, with Quebec accounting for most of the decline. However, the investment in this component was 21.6% higher than the pre-pandemic value in February 2020.

Investment in single family homes edged down 0.6% to $7.0 billion, with declines reported in eight provinces. Conversely, Nova Scotia continued to show strength in this sector (+13.3%), with its fourth increase in five months.

Multi-unit construction investment decreased in seven provinces, down 2.9% nationally to $5.8 billion. The difference in value between multi-unit and single-unit investment had been narrowing for the past few years, but a noticeable gap has opened up since the onset of the COVID-19 pandemic.

Non-residential investment up across all components

Commercial investment grew by 1.8% to $2.6 billion in September, with Ontario and Quebec leading the way. Office building construction projects in Toronto and Ottawa led to gains in Ontario, following three consecutive monthly declines.

Investment in the institutional component rose 2.9% to $1.3 billion, with a 7.9% increase in Quebec. Strength in that province largely stemmed from educational building projects in the cities of Montréal and Laval.

Industrial construction investment edged up 0.1% to $824 million, with gains reported in five provinces. Saskatchewan showed the largest monthly percentage increase (+11.5%), reflecting investment in utility and agricultural buildings.

Overall, non-residential construction investment rose 1.8% to $4.8 billion. Despite eight increases since the beginning of the year, non-residential investment was 6.3% lower than pre-pandemic values.

Residential sector is behind the quarterly decrease

Total investment in building construction decreased 7.5% to $53.0 billion in the third quarter, following substantial growth over the previous four quarters.

Residential construction decreased 10.5% compared with the second quarter, with declines in both single- and multi-unit investment. All provinces posted declines, with the largest in Ontario and Quebec.

Non-residential investment increased 1.8% to $14.1 billion, the third consecutive quarterly increase. Institutional building construction in Ontario and Quebec led the way, partly reflecting increased investment in educational buildings.

Go HERE for more information


 

The EPLAN AdvantageWhat is EPLAN?

One platform, multiple solutions – the Eplan Platform offers engineering software such as Preplanning for systematic preliminary planning, Electric P8 for preparing circuit diagrams and Pro Panel for 3D enclosure planning, all from a single source. Standardised interfaces and integration processes enable continuous data flows throughout the value chain, with additional links to various system solutions from Rittal.

This year, EPLAN has introduced its new EPLAN Platform 2022 to help address challenges in the design, engineering and manufacturing phases of the panel building process...

Read More


 

Changing Scene

  • Prev
The Ontario Electrical League (OEL) is celebrating 100 years of reliability within the electrical ...
ECAO and NECA have announced that on January 1 ECAO officially joined NECA as their 119th Chapter. ...
A virtual event hosted by CAF-FCA to engage employers about the business case for apprenticeship. ...
British Columbian organizations developing low-carbon building solutions can now apply for a third ...
More and more businesses, industries and people are going ‘grid independent.’ This means Licensed ...
CSA Group, a global leader in Testing, Inspection and Certification, has announced the opening of a ...
Sense announced a new standards-based open source effort to enable software to ...
In November, the 2021 Virtual AD Supplier Summit Industrial & Safety–Canada Division event saw ...
Electro-Federation Canada (EFC), through the support of its members, is proud to support university ...
 Ontario is investing an additional $90 million over three years to further promote the ...


EIN NECA ECAO 400ECAO and NECA have announced that on January 1 ECAO officially joined NECA as their 119th Chapter. Executive Director Graeme Aitken joined NECA CEO David Long on LinkedIn Live to announce the partnership.

Given the similarities between the two organizations, ECAO is looking to create more opportunities for its electrical contractor members and this further collaboration will allow them to facilitate that. As well as drawing on the educational opportunities that NECA can offer.

“What we’re looking for is integration, professionalism, but most importantly to expand our community."

Read more


 

Canadian Electrical Contractor Discussion Group: Can You Count the Deficiencies?

EIN CECD 400Have you ever been called to fix the work of a 'handyman'?

"Was supposedly done by a"certified ' electrician....told the homeowner that he got a $266 permit....no record at TSBC. Can you count the deficiencies?"

"There is a second panel change in the triplex also.......even more deficiencies. Think the guy was a glorified handyman. Ones not obvious: 240 BB heat hooked up 120....drier on 2p20....range on 2p50....water heater fed with 2c14 Bx on 2p15."

Go HERE to join the discussion

 


 



 

 ESABy Blake Marchand

This technical Q&A was done as part of ESA’s annual Licence Holder Meeting on November 18th. A recording of the entire meeting is available online. The technical Q&A began with a general overview of ESA’s top 5 changes provided to the 2021 Canadian Electrical Code by Malcom Brown. 

Following that, Brown goes through a number of questions submitted by LECs (Licenced Electrical Contractors), covering several topics, including EV energy management systems, GCFI and AFCI protection, nuisance tripping for washing machines and microwaves, smoke alarm requirements, and common inspection defects.

Read More


 

Product News

  • Prev
Low-dosage LED UVC device for continuous disinfection in occupied spaces provides an additional ...
Greenlee, part of Emerson’s professional tools portfolio, introduces the new ESG45LX Gator Hard ...
The Fluke 417D is accurate, durable, and easy to use—just point and shoot. The simple design and ...
Mercmaster™ LED Luminaires deliver exceptional efficiency, performance and advanced engineering. ...
The SSW Series of Sealed Screwless Wall Plates from SensorSwitch™ is designed to protect wall ...
The Fluke TiS75+ thermal camera offers features to help tackle almost anything teams face in the ...
The M18 FUEL™ 1/2" Hammer Drill is one of the industry's most powerful brushless battery powered ...
Klein Tools introduces the KTB1000 Portable Power Station, providing up to 1500W of continuous ...
Eureka announced the release of its Billie large-scale architectural luminaire. With its ...
The Amprobe BT-250 Circuit Breaker Tester works on powered systems from 90 to 250 V AC and is ...


Gator Hard CutterGreenlee, part of Emerson’s professional tools portfolio, introduces the new ESG45LX Gator Hard Metal Cutter, a tool solution for the high-voltage industry, featuring an industry-first shock-load damping system that minimizes released energy while making cuts.

The ESG45LX is ideal for overhead one-handed operation and cuts up to 1/2-inch Rebar (Schedule 60) and EHS Guy Strand and 5/8-inch Ground Rod and Standard Guy Strand. It has a compact, lightweight design, weighing less than eight pounds with battery, and is 33 percent lighter than an earlier model thanks to a redesigned flip-top style latch that reduces overall weight.

Read More


 

 

Peers & Profiles

  • Prev
Watt’s the Word is a recently launched Electrical Industry Podcast hosted by Zack Hartle and ...
Allana Kellett-Jamieson loves working in the electrical sector and is proud of the great focus ...
As the head of ABB Canada's electrification business unit, Éric Deschênes is no newcomer to the ...
Karen Pullen knows what it’s like to be the only woman on a construction site, and as a proud ...
As of February 2021, Martin Stephenson is the new President and CEO of Signify Canada.   ...
This past July, Kerith Richards, who has worked for Service Wire Company for the last seven years, ...
EngWorks was formed in 2004 as an electrical engineering and consulting firm by Allan Bozek, “After ...
Headquartered in Concord, Ontario, Mercury Lighting services national retail, ...
Among the recipients of the 2021 Clean50 Awards announced last month is Carolina Gallo, Vice ...
Sarah Silverstein is a principal with Liteline along side her two brothers Mark and Daniel. ...


Watt's The WordBy Blake Marchand

Watt’s the Word is a recently launched Electrical Industry Podcast hosted by Zack Hartle and Jason Cox, who are Electricians and Electrical Trade Instructors at SAIT (Southern Alberta Institute of Technology).

Cox is a Calgary based Alberta Master Electrician; he’s been an instructor for the past 15-years with a Master of Education, specializing in adult education. He also gets on the tools volunteering every year for the Calgary Folk Festival electrical crew. “I’m interested in education obviously, and we’re hoping to connect our industry, its such a large vast industry,” he said about the podcast.

Read More


 

Copper $US Dollar price per pound

Kerrwil Publications Great Place to Work. Certified December 2019 - December 2020

538 Elizabeth Street, Midland,Ontario, Canada L4R2A3 +1 705 527 7666
©2022 All rights reserved

Use of this Site constitutes acceptance of our Privacy Policy (effective 1.1.2016)
The material on this site may not be reproduced, distributed, transmitted, cached or otherwise used, except with the prior written permission of Kerrwil